Tudor Walters ReportThe Tudor Walters Report on housing was produced by the Tudor Walters Committee of the United Kingdom Parliament in October 1918.[1] Its recommendations set the standards for council house design and location for the next 90 years. The committeeTudor Walters was the chairman. Raymond Unwin, architect to Letchworth Garden City and Hamstead Garden Suburb, was a member. The backgroundIn 1912 Raymond Unwin published a pamphlet, Nothing gained by Overcrowding, outlining the principles of the Garden City.[2] The Local Government Board in 1912 recommended that:
They published five model plans. Two had an additional parlour, four were terraced and one was semi detached. They had an area 820 square feet (76 m2) to 1,230 square feet (114 m2).[3] The First World War indirectly provided a new impetus. The poor physical health and condition of many urban recruits to the army was noted with alarm. This led to a campaign known as "Homes fit for heroes". The Office for Works built the Well Hall Estate in Eltham for workers at the Royal Ordnance Factory in Woolwich. This had been built on Garden City principles with fine Arts and Crafts details. [4] The recommendationsThe committee expected to
Housing was to be in short terraces, spaced at 70 feet (21 m) at a density of 12 per acre (30/ha) in town or 8 per acre (20/ha) in the country. This was to allow the penetration of sunlight even in winter.[4] There was to be secondary access to the sides of semi-detached houses and by ground floor passages through larger terraces. These terraces should be a maximum of eight houses long. The advantages of cul de sacs were noted as cheap method of providing services and preventing through traffic. The Committee noted the advantages of a varied provision of housing types and not restricting an estate to one social class.[4] Deep narrow-fronted byelaw terraced houses were to be avoided as the rear projection reduced air flow and light to the back of the house. (The middle-room problem). Wider frontages were preferred. A Tudor Walters house had an average frontage of 22 feet 6 inches (6.86 m). The living room should be a light room and ideally a through room.[4] Three basic plans were suggested, based on cost and where the cooking would be done:
In addition it was suggested that superior houses would have a parlour. This was a reasonable expectation for the artisan class.[6] A parlour house was to be 1,055 square feet (98.0 m2) and a non parlour house to be 855 square feet (79.4 m2). In the climate of 1918, 85% of the houses needed to be three-bedroom and 15% to be smaller or bigger. Pre-war the divide had been 40%/60%. The bedrooms should be 150 square feet (14 m2),100 square feet (9.3 m2) and 65 square feet (6.0 m2). A parlour of 120 square feet (11 m2) was seen to be adequate, in effect 12 by 10 feet (3.7 m × 3.0 m). It was a quiet room for reading, writing, a sick relative or formal entertaining of non-family visitors.[6] It also suggested the use of district heating using waste heat from power-stations, the use of standardised components, the positioning of community facilities, integration with public transport and phasing the construction of both.[6] Table
The legacyIn 1919 the Government required councils to provide housing, helping them to do so through the provision of subsidies under The Addison Act (Housing Act 1919). The Housing Act 1890 had merely permitted them to do so. They were to be built to the Tudor Walters standards.[8] See alsoReferences
|
Portal di Ensiklopedia Dunia