South Eastern Freeway
South Eastern Freeway is a 73 km (45 mi) freeway in South Australia (SA). It is a part of the National Highway network linking the state capital cities of Adelaide, SA, and Melbourne, Victoria, and is signed as route M1. It carries traffic over the Adelaide Hills between Adelaide and the River Murray, near Murray Bridge, where it is connected via the Swanport Bridge to the Dukes Highway, which is the main road route to Victoria. It was formerly signposted as Princes Highway, which refers to the coastal route from Adelaide to Sydney via Melbourne. It is often referred to by South Australians simply as the freeway, as it was the first freeway in South Australia, and is still the longest, and the only one with "Freeway" in its name rather than "Expressway" or "Highway". South Eastern Freeway includes 500 m (1,600 ft) twin-tube tunnels – the Heysen Tunnels – in the descent towards Adelaide, the first of their kind on the National Highway. RouteSouth Eastern Freeway commences at the intersection with Glen Osmond Road, Cross Road and Portrush Road in Glen Osmond, and heads southeast as a six-lane, dual-carriageway route. As it traverses across – and through, in one section, via the Heysen Tunnels – the Adelaide Hills, and due the fact the freeway is a major freight route, it also features arrester beds and concrete median barriers, with street lighting between Glen Osmond and Crafers. The freeway narrows to four lanes just before it bypasses Crafers, and continues in a south-easterly direction, past Stirling, Hahndorf and Mount Barker, before narrowing further to a two-lane, single-carriageway, crossing the Murray River over the Swanport Bridge, to terminate just east of the crossing in Long Flat, south-east of Murray Bridge. HistoryPrior to the initial construction of the freeway in the 1960s, inbound and outbound road traffic between Adelaide and south-eastern South Australia or Victoria used a two-lane highway originally built in the early part of the 20th century. With growth in Adelaide's population, issues of congestion and safety mandated reconstruction. Studies began in 1962 for a freeway commencing from Crafers, that endpoint selected arguably due to the massive expenditure required with the precedent upgrade of the Mount Barker Road.[clarification needed] Construction began in 1965 from Crafers. The first stage of eastbound traffic lanes were opened in 1967, and the first westbound section opened in 1969. The freeway was opened in stages as construction progressed. The final section bypassing the town of Murray Bridge and connecting to the new Swanport Bridge over the River Murray opened in 1979, providing an alternative to the historic bridge in Murray Bridge. The Adelaide–Crafers Highway extension came as a much-needed upgrade and replacement to the previous link road, the Mount Barker Road,[3] which had been contoured to the Adelaide Hills, giving rise to many steep turns, ascending a tortuous route. The tightest hairpin turn on the Mount Barker Road was infamous as the Devil's Elbow, often the site of car and semi-trailer accidents.[4] On 16 May 1995, Prime Minister Paul Keating announced the construction of the new Adelaide-Crafers section. The Heysen Tunnels, named after well-known South Australian artist and benefactor Hans Heysen, were completed in 1998. Construction was completed in early 2000. In March 2000, Prime Minister John Howard opened the new road.[5] It was the largest South Australian road project at that time, costing A$151 million, wholly funded by the Australian Federal Government. An additional exit was built at Monarto around 1999 to service an expanding commercial zone and the Monarto Zoo in the area.[6] Another exit was announced in 2014 at Bald Hills Road, 4 km southeast of the Mount Barker interchange to service growing housing estates in southern Mount Barker and Nairne.[7][8] Bardavcol started construction in May 2015, with the interchange including entry and exit ramps in both directions. The $27mil project was funded with $16mil by the Federal Government, $8mil by the Government of South Australia and $3mil from the Mount Barker District Council.[9] The new interchange opened on 15 August 2016.[10] The Freeway bypasses many towns previously along the Princes Highway, including: Road safetyShortly after the Adelaide–Crafers section opened, several incidents involving semi-trailers drew media attention to the road. While the previous Mount Barker Road was a notorious stretch, its dangers were well known; the new freeway presented the new challenge of a sustained continuous gradient with traffic lights at the bottom. Heavy vehicles with inadequate braking found it hard to slow down once they had exceeded a certain speed; this was made worse with brake failures. It took some time, and the addition of several warning signs prior to the descent, for heavy vehicles to become familiar with the freeway's characteristics. Semi-trailers can be seen travelling as slow as 20–30 km/h downhill. In 2005 changeable electronic road signs were installed every 200 metres, so that the speed limit of the road can be adjusted from Transport SA headquarters in Adelaide. This has both improved safety for commuters, and emergency service workers like the Country Fire Service. In 2010 and 2011, after more incidents involving trucks having problems successfully braking down the hill, including one going into a bus stop, and another going straight through the intersection at the bottom, the government added new laws that any vehicle with 5 axles or more must stay in the left lane and must not exceed a 60 km/h limit from the interchange at Crafers to the old tollhouse. More safety cameras were installed in an attempt to ensure trucks abide by this new limit. Additional signs for the two arrester beds on the descent have been added, to encourage out of control drivers to use them as a safer alternative. In August 2014, another truck descending the hills collided with cars at the intersection of Glen Osmond Road. Two people were killed.[11] A driver of a sewage truck lost control after passing the arrestor beds. The driver was a new employee, who had never driven a manual truck before, and had never driven any vehicle on this segment of road.[12] Driver Darren Hicks was seriously injured and testified against employer Cleanaway at a criminal trial after being granted immunity.[13] The prosecution, brought by Comcare, heard that the brakes on the vehicle were defective. In 2021 Cleanaway was convicted of eight charges under health and safety legislation.[14] ConnectionsThe Adelaide end of South Eastern Freeway leads downhill to traffic lights at the intersection of Glen Osmond Road which continues northwest as route number A1 into the Adelaide city centre, Portrush Road north to bypass the city and towards Port Adelaide, and Cross Road which leads west towards the southern suburbs of Adelaide. The southeastern end of the freeway, near Murray Bridge, feeds onto the Swanport Bridge, a two-lane, 1-kilometre-long (0.62 mi) bridge over the River Murray, where it joins Princes Highway, a dual-carriageway highway to Tailem Bend. At this point, Highway 1 becomes a two-laned, two-way scenic route which passes through many coastal towns of South Australia and Victoria. The National Highway continues to Melbourne as Dukes Highway (A8) from Tailem Bend to the Victorian border and beyond as Western Highway. Exits and intersections
Gallery
See also
References
External links
|