The TR-1700 (Santa Cruz) is a class of diesel-electric patrol submarines built by Thyssen Nordseewerke for the Argentine Navy in the 1980s, with two submarines completed. These ships are amongst the largest submarines built in Germany since World War II and are among the fastest diesel-electric submarines in the world.[3]ARA San Juan was lost on 17 November 2017, leaving ARA Santa Cruz as the only remaining submarine of this class. As of 2020, the refit of Santa Cruz has been reported cancelled leaving the entire class inactive.[4][5]
Development
This section needs expansion. You can help by adding to it. (January 2016)
The original 1977 plan called for six boats, two TR-1700s built in Germany by Thyssen Nordseewerke, two in Argentina by Astillero Domecq Garcia, and two smaller TR-1400s also built in Argentina.[6] The final agreement in 1982 was modified to six TR-1700s, with the last four to be built in Argentina.[7]
Possible nuclear propulsion
The TR-1700s to be built in Argentina were considered for an upgrade to a nuclear submarine. The use of INVAP's CAREM reactor for that purpose is an 'urban myth,' as such design is inadequate for moving platforms.[1] The nuclear submarine project never came to fruition, despite later attempts to revive it.[8]
The reasons why INVAP's reactor is inviable stem from a number of reasons.[9] The main reasons are:
The reactor was not designed from scratch for moving platforms and relies on the naïve and dangerous concept of "one reactor fits all purposes".
The design has not considered the dynamic and operational characteristics of the porting platform. This causes problems in the following areas:
Thermal problems due to the large diameter of the pellets (7.6mm), which do not allow sudden power ramps, required in a submarine.
Wrong type of control rod mechanisms, not adequate for a rolling and pitching vessel. For example, nut-shell control rods would be more appropriate.
The continuous movement of the large liquid free-surface inside the reactor, as experienced in vessels of any type (surface or submerged), leave fuel unexposed and, thus, not refrigerated.
Steam generators located inside the reactor vessel (instead of outside) increase the diameter of the vessel and thus its weight, unnecessarily, restricting the operational characteristics of the submarine.
Inconvenient coupling of various variables due to auto-pressurization.
Lack of land prototype on a moving platform (not static). See figure to the right for a Westinghouse prototype for submarines.
Numerical simulations for untested designs are not enough, and are only the first step in a series of validations that have to agree with actual experiments. Before offering a reactor as a proposal, any contractor—at their own expense—should perform experiments on moving platforms (water tanks excited to reproduce ship movements) located on land, and demonstrate that they work and agree with the numerical simulations. The reactor should be identical to the reactor proposed to be fitted in a ship or submarine.
Design
The TR-1700 submarine was designed by Thyssen and its features include high underwater speed, endurance (for a diesel submarine), and survivability. The boat's four MTU 16V652
MB80 diesel engines, four generators, and Siemens electric motor can propel it at speeds up to 25 knots (46 km/h; 29 mph).[10][11] Eight 120-cell banks of VARTA batteries are installed on each boat.[12] They have a diving depth of 300 m (980 ft).[2] Normal endurance of these boats is 30 days[1] with an extended range up to 70 days.[citation needed] These boats are equipped to accept a Deep Submergence Rescue Vehicle (DSRV).[citation needed] Armaments include six bow 533 mm (21 in) torpedo tubes and space for 22 torpedoes.[13] The TR-1700 can launch a variety of weapons via its torpedo tubes, such as the wire-guided SST-4 torpedo and the Mark 37C short antisubmarine torpedo.[12] The automatic torpedo reload system can reload sixteen times and reloading the tubes takes 50 seconds.[13][1]
When it comes to the electronics and systems the TR-1700 has a HSA SINBADS Action Information Organisation and Fire Control System that is combined with a SAGEM plotting table.[12] The radar consists of the Thomson-CSF Calypso and it has a Atlas Elektronik CSU 3/4 and Thomson Sintra DUUX-5 as sonars.[13]
Thyssen proposed the TR1700A for the Australian Collins-class submarine program.[14] The proposed design had a reworked pressure hull, was six meters longer, and half a meter wider than the TR-1700s built for Argentina. It lost to the Type 471 from Kockums, an enlarged Västergötland-class submarine.
Service
The first two submarines were delivered on schedule in 1984–85.[13] The remaining four built in Argentina were suspended due to the Argentinean economic crisis of the 1980s.[citation needed] In 1996 work completely ceased on ARA Santa Fe at 70% (or 52%) completion while ARA Santiago del Estero was only 30% complete.[15] After attempts to complete and sell the boats to Taiwan failed, they were cannibalized, along with the parts for the fifth and sixth units, to support the continued operations of the first two submarines.[3]
Santa Cruz received its mid-life modernization at Arsenal de Marinha, Rio de Janeiro Brazil between September 1999 and 2001.[6] The work involved the replacement of the engines, batteries, and sonar. Her sister boatSan Juan entered the Astillero Domecq Garcia shipyard to receive her refit in 2007;[16] she completed refit in 2013.[17]
In September 2010, it was revealed that the Ministry of Defense was conducting feasibility studies to decide if ARA Santa Fe (S-43) should be completed. The decision should be made sometime after completing the mid-life modernization of ARA San Juan (S-42). The estimated cost of completing Santa Fe was $60 million.[18][19]
On 17 November 2017, the ARA San Juan was reported missing; reports of a fire at the time were denied by the Argentine Navy.[20][21]
A year after that, on 17 November 2018, private company Ocean Infinity (appointed by the Argentine Government) announced that they successfully located the wreck, at 900 metres depth and 500 km from Comodoro Rivadavia.[22]
Formerly in service with Argentine Navy. Confirmed lost on 23 November 2017; wreck found in Atlantic Ocean on 16 November 2018. Recovery by American team pending naval decision.
Construction suspended - 70% (or 52%) complete[23] Boat could be completed after feasibility studies. Unknown if sub was cannibalized for parts along with the rest of incomplete members of the class.[citation needed]
ARA Santiago Del Estero
S-44
Astillero Domecq Garcia
Construction suspended - 30% complete and eventually cannibalized for spare parts for active subs.[citation needed]
(none)
S-45
Astillero Domecq Garcia
Construction suspended - Little complete[15] Components cannibalized for spares
^ abcdeGardiner, Chumbley and Budzbon (1995), p. 11.
^Woolner, Derek (18 September 2001). Procuring Change: How Kockums was Selected for the Collins Class Submarine. Canberra: Department of the Parliamentary Library. p. 34.
^ abcWertheim, Eric (2002). Naval Institute Guide to Combat Fleets of the World: Their Ships, Aircraft, and Systems. US Naval Institute Press. p. 1124. ISBN1-59114-955-X.
![[icon]](File:Wiki_letter_w_cropped.svg){kind=small}
